Options & Accessories
- 2nd Slitting Knife
- 16″ and 20″ Inner Diameter Recoiling Spindle
- 12 ft. Blanking Table
- Perforation Die Stage for Soffit venting
- 3000 Lbs. capacity Decoiler for your “master coil”
Coil Processor Slit, Blank and Recoiler
This machine is ideal for the Metal Roofing Contractor or Sheet Metal Fabrication shop to process a maximum width 24″ coil into smaller widths and lengths for the many Trim / Flashing products being used today.
Recoil, blank sheets, slit, and perforate your metal with this affordable unit!
Complete with hydraulic drive and hydraulic scissors shear, Digital Controller, one (1) Slitting Knife, and a 3000 Lbs. recoiling capacity.
Description
Related products
RTR-16/15 Gutter Recoiler Machine
The RTR 16/15 Gutter Coil Recoiler is ideal for the “Rain Ware”/Gutter Supply company to process a Gutter Coil into smaller coils of either the 11 ¾” or 15″ width with a 300 Lbs. maximum recoiling capacity.
The RTR 16/15 Recoiler uses a digital Controller and manual shear.
This unit gives you the ability to spin down coils in a safe, efficient, and accurate way to save you and your customer time and money.
CTL-48 48 Inch Cut-To-Length Machine with Hydraulic Drive and Shear
This machine is ideal for the Metal Roofing Contractor or Sheet Metal Fabrication shop to process a maximum width 48″ coil into smaller widths and lengths for the many Trim / Flashing products being used today.
Complete with hydraulic drive and Tennsmith Shear, Digital Controller, and two (2) slitting knives.